About the Rife Tubes and Pricing


	Barry Allred is considered one of the true pioneers in Rife Tube development and innovation. His focus over the years has not been so much in Rife development itself ... but rather working closely with the Rife “developers” themselves utilizing their direct feedback and needs to provide the absolute best plasma tubes available to the Rife experimenter.


	Barry was the developer of the single, double, and triple bubble tubes allowing for great increase in the volume of gas which can be excited by either RF or high voltage units.

The “Getter” is standard issue on all tubes regardless of configuration to absorb impurities that leach from the glass over time which would cause a degeneration in tube performance. While the unit provides continuous self cleaning in the high voltage circuits .... in the Bare-Rife environment, it need only occasionally be excited with a neon transformer clipped to the ends to bring the gas back into pristine, like “new” condition.


	The protective vinyl end caps which encompass and protect the internal electrodes are also standard issue and assist in easier mounting. In the high voltage (EMEM-type) devices these make clean entry points to securely hold your cable and provide necessary strain relief)


	Barry has developed a technique for safely allowing much higher pressures of 16 torr and better than the typical 6-8 torr of most other tubes. Although some say it might be a bit harder to light, it allows for a very tight and concentrated beam the full length of the tube. Many have emphasized that this “concentrated” beam appears to maximize the radiant effect we most desire.


	E-Gas is the signature mixture ... the sort of “secret sauce” of Rife plasma gas mixtures. This mixture has been developed over many years in conjunction with Rife builders, feedback and responses. If you are running any of the high voltage type devices (EMEM-type) this IS THE “performance GAS” for you !!!!.


	Please Note: this mixture cannot currently be used on typical high power Bare-Rife units. (The exceptional reactivity causes it to run far to hot in that environment although this is being closely examined as a possibility for low power Bare-rife units which do not incorporate a linear amplifier or do not run exceptionally high power.)

Working with Rife developers and experimenters has necessitated many unusual but very useful custom designs .

If you have a unique need, feel free to contact Mr. Allred personally to discuss how that might be reasonably accommodated.


	Go to the RIFE TUBE CATALOG


	Home of


	Credit Cards gladly accepted via


		WebSite administration and management by


	This WebSite Copyright 1998 - 2001, J.L. Holman/Allred Neon, all rights reserved (requests for component use WILL be granted with proper notification)